JH5 TRAK LPM Vertical Machining Center
The TRAK LPM System
The ProtoTRAK PMX CNC — technology that simplifies CNC complexity
- Powerful but easy to learn and use
- PMX technology eliminates the “sea of buttons” normally associated with VMCs
- Integrated into the TRAK LPM VMC
- 3-axis CNC, 3-axis DRO (4th axis option)
- Runs ProtoTRAK conversational language, G-code, CAM, 2 and 3-D CAD conversion software, and Verify Machining Simulation software
For cost effective, high-mix, low-volume work
Designed to be easy to learn and use, the TRAK LPM incorporates technologies to markedly reduce the changeover times that plague high-mix, low-volume shops. It is the only VMC to integrate the machine, control, fixturing, and tool offset measurements into one complete system.
This means that it doesn’t require expensive probing systems that consume spindle time to measure offsets. It also means that it doesn’t require a room full of special fixture to facilitate quick changeovers.
Other manufacturers install a general-purpose production CNC on a machine, load in a few parameters and leave it at that. The ProtoTRAK PMX goes beyond to reduce your work in setup.
Standard Features
- Internal wash down nozzles
- Air gun
- Wash down gun
- Halogen work lights
- Auto lube system
- Mobile Tool setting system (incl. cart)
- Belt drive spindle
- Coolant pump
- Wash down pump
- Fixture clamping devices – set of 4
- Status lights
- Rigid tapping
- Chip Auger (accommodates a third party 12” oil skimmer)
- Air blast to clear chips from spindle